The new Klark Teknik DN100 Direct Injection Box is the natural successor to the long-established LBB100.
A ground-up redesign provides an extended dynamic range, lower noise floor and all the world-class audio performance you’d expect from Klark Teknik. DN100 is also designed to handle the rigours of life on the road: a thick aluminium shell protects the electronics, and this in turn is protected by a tough silicone rubber casing, which is replaceable and available as a spare part.
We’ve also fitted a Kensington security slot in one of the end panels to allow the unit to be made secure using a Kensington MicroSaver security cable.
Attention to detail – it’s what makes a good unit into a great one.
Type active electronic, balanced or unbalanced
Impedance 1M Ω nominal, balanced or unbalanced (jack connectors) 20K Ω (XLR input only)
Connectors 2 quarter inch jacks and 3-pin XLR linked in parallel
Maxmum level 30dBu
Attenuator 30dB switchable
Type Transformer Isolated, balanced
Impedance 300 Ω
Connector 3 pin XLR
Max. Level 10dBu with load >2k Ω
Min. load 600 Ω
Noise -100dBu, 20Hz to 20kHz unweighted, with input terminated by 10k resistor
Frequency response +0.5/-1dB 20Hz to 20kHz
Distortion (THD+N) output <0.01% @ 1kHz, +4dBu
Voltage +48V Phantom *
Current consumption <10mA
Length 142mm (5.6 inch)
Width 106mm (4.2 inch)
Height 60mm (2.35 inch)
* The DN100 has been designed to allow use at phantom voltages less than +48V. The unit will function down to +20V (when used with 6k8 dropping resistors) but with reduced headroom and dynamic range. All the specifications above are quoted using standard +48V Phantom power.
Trade Descriptions Act:
Due to the company policy of continuing improvement, we reserve the right to alter these specifications without prior notice. E&OE.
*Prices are in AUD, include GST and are subject to change. Please call National Audio for pricing and availability on the DN100.